|
ULTRASONIC - THERMAL INSERTS |
| SONICSERT is designed specifically for STRAIGHT hole configurations, post molding |  |
| SONICSERT I is specifically designed for straight hole configurations,
post molding. Opposed herringbone knurl provides exceptional torque resistance, while the
undercuts ensure optimum tensile strength. A lead in pilot flange allows for true
perpendicular alignment during assembly. Designed with the smallest possible outside
diameter. the SONICSERT I is ideal for structural foams, failure-prone or brittle 'Stress
Risk' plastics and thin walled applications. The SONICSERT I is available in many other
lengths than the standard ones listed in the specification chart below. HOLE SIZE:
Recommended hole sizes for the SONICSERT I are listed in the chart below ("D"
Dimension). Please note that hole sizes are not necessarily core pin sizes. The core pins
should be designed to allow for shrinkage of the plastic. For easier release of core pins,
a 1 degree overall taper is acceptable. The depth of the hole for our SONICSERT I series
should be equal to the insert length plus .010"-.050" minimum to contain any
flash that might be displaced. BOSS DIAMETER: The outside boss diameter for the SONICSERT I should be two times the
diameter of the insert being used. It can be ordered with external threaded stud and/or
flanged head. |
For Specifications Table CLICK HERE
| Email: Info@EisInserts.com |
| TEL: (860) 274-3628 - FAX: (860) 274-7939 |